Skip to content
Head Up Display
Components of Head Up Display
- HUD presents flight information and guidance in a pilot’s visual line of sight
- In critical phases of flight, like take off or landing the system is very useful
- Head Up Display system consists of four components
- Display controller to control various modes
- Display guidance computer to generate symbology
- Overhead unit which is a projector
- Combiner which is a glass screen to reflect displays to pilot
- Ambient light sensor controls brightness and adjusts display brightness
- Display brightness is adjusted as per lighting in flight deck
Eye Box
- Overhead unit uses a collimator to produce parallel light source
- Collimator projects the display to an eye reference point
- Eye reference point is the ideal position for image
- Ideally the image must meet the eye at infinity
- Parallax error must be avoided
- Eye box is also called head motion box determines the head movement
- HUD is visible in a 3 d box around his eye reference point
- The box is normally 5 inches wide, 3 inches high and 6 inches deep
Bore Sighting
- Head up display should project a conformal image
- Conformity avoids disorientation when taking over visual
- Real object its image on the combiner are aligned when real object is visible
- Conformity is achieved by construction of a correct image
- Correct image means it has at the correct perspective and size for object range
- Bore Sighting is the process of correct alignment of object with its image
- Object and its image must vary by less than half a degree
Advancements in Head Up displays
- First generation displays used cathode ray tube with projectors and combiners
- Fading problems and high voltage requirements were drawbacks
- Solid state light source replaced cathode ray tubes in second generation
- Lower voltage and lesser fade with wider field of view and sharp images
- Third generation used optical wave guides instead of overhead projector
- Eye box was increased considerably
- Phosphor coated wind screen is being used to replace combiner
- Windscreen is being used as a display in the fourth generation head up
Information Display
- Mandatory information
- Air Data Computer
- Inertial Reference Unit
- Radio Altimeter
- Radio Navigation
- Flight Management System
Tunnelling Effect in Head Up Display
- Tunnelling is caused by attention capture and over dependence
- Pilots tend to disregard external visual reference
Cluttering in Head Up Display
- Cluttered display obscures visual information cues
- Confuses the pilot at times
Enhanced Vision in Head Up Display
- Enhanced vision system help in night flying
- Forward looking infrared creates a heat map type image at night
Synthetic Vision in Head Up Display
- Synthetic vision system helps during flight in instrument met conditions
- Displays computer generated graphics on screen
Share this Page
Scroll Up